Allied Telesis AT-S39 - Manual (Page 41)

AT-S39 User’s Guide
41
9 - Reset Switch
This selection resets the switch.
A - Server-based Authentication
This selection is used to configure the TACACS+ and RADIUS
authentication protocols on the switch. For information on this
feature, refer to Chapter 17, TACACS+ and RADIUS Protocols
on page 191.
Downloads and Uploads
For information on this selection, refer to Chapter 20, File
Downloads and Uploads on page 213.
R - Ping a Remote System
For information on this selection, refer to Pinging a Remote
System on page 53.
3. After you have set the parameters, type S to select Save Configuration
Changes.
Note
A change to any of the parameters in this menu, including the IP
address, subnet mask, or gateway address, are immediately
activated on a switch.