Modifying a vlan – Allied Telesis AT-S39 User Manual

Page 144

Section II: Local and Telnet Management

144

Modifying a VLAN

Note
To modify a VLAN, you must know the VLAN VID. To view VLAN VIDs,
refer to the procedure Displaying VLAN Information on page 147.

To modify a VLAN, perform the following procedure:

1. From the Main Menu, type 2 to select VLAN Menu.

2. From the VLAN Menu, type 5 to select Configure VLANS.

3. From the Configure VLANS menu, type 2 to select Modify a VLAN.

The Modify a VLAN menu in Figure 39 is displayed.

Figure 39 Modifying a VLAN Menu

4. Type 1 to select VLAN ID (VID).

The following prompt is displayed:

Enter new value -> [1 to 4096] ->

5. Enter the VID of the VLAN you want to modify. Press Return.

The Modify a VLAN menu for the selected VLAN is displayed. This
menu contains all relevant information about the VLAN.

6. Change the VLAN’s information as desired.

The menu selections are described below:

1 - VLAN Name
Use this selection to change a VLANs name. The name can be from
one to fifteen characters in length. The name should reflect the
function of the nodes that will be a part of the VLAN (for example,
Sales or Accounting). The name can contain spaces, but not special
characters, such as asterisks (*) or exclamation points (!).

Allied Telesyn Ethernet Switch AT-8024

Modify VLAN

1 - VLAN ID (VID) ........

S - Save Configuration Changes
R - Return to Previous Menu

Enter your selection?