Allied Telesis AT-S39 - Manual (Page 31)

AT-S39 User’s Guide
31
Note
The switch has an auto-detect feature on the serial port that
auomatically determines the speed of the local terminal. Activate
this feature by pressing the Return or Enter key twice on your
keyboard when you initially start the local interface or within five
seconds after powering on or resetting the switch. The switch
responds by determining the speed of the terminal and
automatically configuring the speed of the RS232 Terminal Port
accordingly. Otherwise, the switch uses a default baud rate of 9600
bits per second (bps). The switch maintains the terminal port speed
until the system is again powered on or reset. The range of the port’s
baud rate is 1200 to 115200 bps.
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
Note
During boot up, the switch displays the following prompt:
Press
any key to stop image loading and go to Boot
Prompt
. This message is intended for manufacturing purposes
only. (If you inadvertently display the boot prompt (=>), type boot
and press Return to start the switch.)
4. Press the Return key twice.
If prompted for a password, enter the password for the
management software. The default password for manager access
is “friend”. The default password for operator access is “operator”.
Logins and passwords are case-sensitive. For information on the
two access levels, refer to Management Access Levels on page
25. (For instructions on how to change a password, refer to
Configuring the Management Passwords on page 48.)