Allied Telesis AT-S39 - Manual (Page 225)

AT-S39 User’s Guide
225
Uploading Files
To upload a management software image or configuration from a switch
onto your management station, perform the following procedure:
Note
It is not recommended that you upload an AT-S39 software image
onto a management workstation for download onto another
switch. New AT-S39 software images for downloading onto a switch
should only be obtained from the Allied Telesyn web site.
1. Start a local management session on the switch where you intend to
upload the management software image or configuration file.
For instructions, refer to Starting a Local Management Session
on page 30.
2. From the Main Menu, type 4 to select Administration Menu.
3. From the Administration Menu, type D to select Downloads &
Uploads.
The Downloads and Uploads menu in Figure 60 on page 217 is
displayed.
4. To upload the AT-S39 software image and bootloader from the
switch, type 3. To upload a configuration file, type 4.
The following prompt is displayed:
Download Method/Protocol [X-Xmodem, T-TFTP]:
5. To upload a file using Xmodem, go to Step 6. Upload a file using TFTP,
do the following:
a. Type T.
The following prompt is displayed:
TFTP Server IP address:
b. Enter the IP address of the TFTP server.
The following prompt is displayed:
Remote File Name:
c. Enter the file name that the image file or configuration file is to be
stored under on the TFTP server.
Once the filename has been specified, the upload begins.
Uploading a configuration file takes only a few moments.
Uploading an AT-S39 image file can take several minutes.