Allied Telesis AT-S39 - Manual (Page 142)

Section II: Local and Telnet Management
142
Creating a Port-based VLAN Example
The following procedure creates the Sales VLAN illustrated in Figure 33
on page 124. This VLAN will be assigned a VID of 2 and will consist of four
untagged ports, Ports 1 to 4. The VLAN will not contain any tagged ports.
The VLAN traffic will not be mirrored on another port.
To create the example Sales VLAN, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Menu.
2. From the VLAN Menu, type 5 to select Configure VLANS.
3. From the Configure VLANS menu, type 1 to select Create VLAN.
4. Type 1 to select VLAN Name and enter “Sales”. Press Return.
5. Type 2 to select VLAN ID (VID) and enter “2”. This is the VID value for
the new VLAN. Press Return.
6. Type 4 to select Untagged Ports and enter “1-4”. These are the
untagged ports of the VLAN. Press Return.
7. Type C to select Create VLAN.
8. After the switch displays the prompt notifying you that it created the
VLAN, press any key.
9. Type S to select Save Configuration Changes.
The new Sales VLAN has been created.