Allied Telesis AT-S39 - Manual (Page 105)

AT-S39 User’s Guide
105
Enabling or Disabling STP or RSTP
To select and activate a spanning tree protocol, or to disable spanning
tree, perform the following procedure:
1. From the Main Menu, type 3 to select Spanning Tree Menu.
The Spanning Tree Menu in Figure 27 is displayed.
Figure 27 Spanning Tree Menu
2. To enable or disable spanning tree, type 1 to select Spanning Tree
Status.
3. Type E to enable spanning tree or D to disable it. The default is
enabled.
4. To change the version of spanning tree protocol running on the
switch, type 2 to select Active Protocol Version.
Note
Changing the spanning tree version will reboot the switch.
The following prompt is displayed:
The switch will be rebooted for changing the
protocol version.
Do you want to continue? [Yes/No]
5. Type Y for yes to change the current version of spanning tree and
reboot the switch, or N to cancel this procedure.
6. If you activated spanning tree and you selected STP, go to
Configuring STP on page 106 for further instructions. If you selected
RSTP, go to Configuring RSTP on page 110
Allied Telesyn Ethernet Switch AT-8024
Login Privilege: Manager
Spanning Tree Menu
1 - Spanning Tree Status ...... Disabled
2 - Active Protocol Version ... RSTP
3 - STP Configuration
4 - RSTP Configuration
S - Save Configuration Changes
R - Return to Previous Menu
Enter your selection?