Allied Telesis AT-S39 - Manual (Page 106)

Section II: Local and Telnet Management
106
Configuring STP
This section contains the following procedures:
❑ Configuring a Bridge’s STP Settings on page 106
❑ Configuring a Port’s STP Settings on page 108
Configuring a
Bridge’s STP
Settings
This section contains the procedure for configuring a bridge’s STP
settings.
Caution
The default STP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how STP works might have a negative effect on your network. You
should consult the IEEE 802.1d standard before changing any of the
STP parameters.
1. From the Spanning Tree Menu, type 3 to select STP Configuration.
The STP Menu in Figure 28 is displayed.
Figure 28 STP Menu
Allied Telesyn AT-8024 Ethernet Switch
Login Privilege: Manager
STP Menu
The current protocol version is STP.
1 - Bridge Priority ..... 65535
2 - Bridge Hello Time ... 2
3 - Bridge Forwarding ... 15
4 - Bridge Max Age ...... 20
6 - Config STP Port Settings
7 - Display STP Port Settings
8 - Reset STP to Defaults
R - Return to Previous Menu
Enter your selection?