Enabling or disabling stp or rstp – Allied Telesis AT-S39 User Manual

Page 267

AT-S39 User’s Guide

267

Enabling or Disabling STP or RSTP

To enable or disable spanning tree on the bridge, do the following:

1. From the Home page, select Configuration.

2. From the Configuration page, select Layer 2.

3. From the Layer 2 page, select the Spanning Tree tab.

The Spanning Tree tab in Figure 82 is displayed.

Figure 82 Spanning Tree Tab

4. To enable or disable spanning tree, click the Enable Spanning Tree

check box. A check indicates that the feature is enabled while no
check indicates that the feature is disabled. The default is disabled.

5. If you are activating spanning tree, click either STP or RSTP in the

Active Protocol Version section of the menu. The default is RSTP.

Note
Only one spanning tree protocol can be active on the switch at a
time.

6. Click Apply.