Allied Telesis AT-S39 - Manual (Page 110)

Section II: Local and Telnet Management
110
Configuring RSTP
This section contains the following procedures:
❑ Configuring a Bridge’s RSTP Settings on page 110
❑ Configuring a Port’s RSTP Settings on page 112
Configuring a
Bridge’s RSTP
Settings
This section contains the procedure for configuring a bridge’s RSTP
settings.
Caution
The default RSTP parameters are adequate for most networks.
Changing them without prior experience and an understanding of
how RSTP works might have a negative effect on your network. You
should consult the IEEE 802.1w standard before changing any of the
RSTP parameters.
1. From the Spanning Tree Menu, type 4 to select RSTP Configuration.
The RSTP Menu in Figure 30 is displayed.
Figure 30 RSTP Menu
Allied Telesyn Ethernet Switch AT-8024
Login Privilege: Manager
RSTP Menu
The current protocol version is RSTP
1 - Force Version .......... RSTP
2 - Bridge Priority ........ 32768
3 - Bridge Hello Time ...... 2
4 - Bridge Forwarding ...... 15
5 - Bridge Max Age ......... 20
6 - Bridge Identifier ...... 00:30:84:52:03:80
P - RSTP Port Parameters
D - Reset RSTP to Defaults
S - Save Configuration changes
R - Return to Previous Menu
Enter your selection?