Allied Telesis AT-S39 - Manual (Page 287)

AT-S39 User’s Guide
287
Setting the Switch’s Mode
This section contains the procedure for setting a switch’s mode. You can
configure a switch to Tagged mode or Basic mode.
Note
For descriptions of switch modes and VLAN modes, refer to Virtual
LANs Overview on page 115.
To set the switch’s VLAN mode, perform the following procedure:
1. From the Home Page, select Configuration.
2. From the Configuration menu, choose System.
3. Select the General tab.
4. In the Switch Mode section of the menu, click either Tagged or Basic.
If you select Tagged, which is the default, the switch will support
both port-based VLANs and tagged VLANs. If you select Basic, the
switch will operate in the Basic mode.
5. Click Apply.
6. Click Reset to reset the switch.
A change to VLAN status is not activated until the switch is reset.