Allied Telesis AT-S39 - Manual (Page 108)

Section II: Local and Telnet Management
108
Configuring a
Port’s STP
Settings
To adjust a port’s STP parameters, perform the following procedure:
1. From the Spanning Tree Menu, type 3 to select STP Configuration.
2. From the STP Configuration menu, type 6 to select Config STP port
settings.
The following prompt is displayed:
Starting Port to Configure [1 to 24] ->
3. Enter the number of the port you want to configure. To configure a
range of ports, enter the first port of the range.
The following prompt is displayed:
Ending Port to Configure [1 to 24] ->
4. To configure just one port, enter the same port number here as you
entered in the previous step. To configure a range of ports, enter the
last port of the range.
The STP Port Configuration menu in Figure 29 is displayed.
Figure 29 Config STP Port Settings Menu
5. Adjust the settings as desired. The parameters are described below.
6. After adjusting the parameters, type S to select Save Configuration
Changes.
Allied Telesyn AT-8024 Ethernet Switch
Login Privilege: Manager
Config STP Port Settings
Configuring Ports 4 to 4
1 - Participate ....... Yes
2 - Fast Mode ......... No
3 - Port Cost ......... Automatic Update
4 - Port Priority ..... 128
5 - Port State ........ Disabled
6 - Root Bridge .......
S - Save Configuration changes
R - Return to Previous Menu
Enter your selection?