Allied Telesis AT-S39 - Manual (Page 308)

Section III: Web Browser Management
308
Configuring TACACS+ and RADIUS
To configure the authentication protocols, perform the following
procedure:
1. From the Home page, select Configuration.
2. From the Configuration page, select System.
3. From the System page, select the Server-based Authentication tab.
The tab is shown in Figure 97.
Figure 97 Server-based Authentication Tab
4. To enable or disable the authentication feature on the switch, click
the Disable Server-based Authentication check box. A check in the
box indicates that this feature is disabled. No check indicate the
feature is enabled. The default is disabled.
5. To select an authentication protocol, click either TACACS+ or RADIUS
in the Authentication Method section of the menu. The default is
TACACS+.
Note
Only one authentication protocol can be active on the switch at a
time.
6. Click Apply.