Allied Telesis AT-WA7500 User Manual

Page 96

4 - Configuring the Radios

2. For each frame type, check or clear each check box. The frame types

are described below:

Allow IAPP

Determines if this radio accepts IAPP frames from other access
point station radios. The IAPP frames must match Ethernet
protocol 875c.

Allow Wireless Transport Protocol (WTP)

Determines if this radio accepts WTP frames from end devices.
The WTP frames must match Ethernet protocol 875b.

Allow SpectraLink Voice Protocol (SVP)

Determines if this radio accepts SVP frames from voice wireless
telephones. The SVP frames must match IP 119.

Allow UDP Plus (UDP/IP Port 5555)

Determines if this radio accepts UDP Plus frames from end
devices. The UDP Plus frames must match the UDP network port
5555 on the DCS 30X or ARP.

Allow DHCP

Determines if this radio accepts DHCP frames. The DHCP frames
must match UDP destination port 67 and ARP. Check this check
box if the end devices are DHCP clients.

Allow All Other Protocols

Determines if this radio accepts all other protocols that are not
filtered by one of the filters in this screen.

3. Select Submit Changes to save your changes. To activate your

changes, select Save/Discard Changes from the menu bar then Save
Changes and Reboot. For help, see Saving Configuration Changes
on page 41.