Allied Telesis AT-WA7500 User Manual

Page 128

5 - Configuring the Spanning Tree

128

2. For each frame type field, check or clear the check box to configure if

the frame types are passed or are dropped. If you check the check
box, the frame type is allowed to pass.

For each frame type field, set the Scope field to Unlisted or All.

The parameters are describe below:

DIX IP TCP Ports

DIX IP UDP Ports

SNAP IP TCP Ports

SNAP IP UDP Ports

Primary Internet Protocol Suite (IP) transport protocols.

DIX IP Other Protocols

SNAP IP Other Protocols

IP protocols other than TCP or User Datagram Protocol (UDP).

DIX IPX Sockets

Novell NetWare protocol over Ethernet II frames.

SNAP IPX Sockets

Novell NetWare protocol over 802.2 SNAP frames.

802.3 IPX Sockets

Novell NetWare protocol over 802.3 RAW frames.

DIX Other Ethernet Types

SNAP Other Ethernet Types

DIX or SNAP registered protocols other than IP or IPX.

802.2 IPX Sockets

Novell running over 802.2 Logical Link Control (LLC).

802.2 Other SAPs

802.2 SAPs other than IPX or SNAP.

3. Select Submit Changes to save your changes. To activate your

changes, select Save/Discard Changes from the menu bar then Save
Changes and Reboot. For help, see Saving Configuration Changes
on page 41.

4. If you set the Scope field to Unlisted for any of the frame types, you