Allied Telesis AT-WA7500 - Manual (Page 58)

3 - Configuring the Ethernet Network
58
6. Select DHCP Server Setup. The DHCP Server Setup screen appears.
7. Configure the DHCP server. The DHCP parameters are described
below:
Low Address
Enter the low IP address in the range of IP addresses available to
the DHCP server for distribution to DHCP clients.
If these addresses are not on the same subnet as the access point,
the access point will perform Network Address Translation (NAT)
for the clients to which it grants IP addresses.
High Address
Enter the high IP address in the range of IP addresses available to
the DHCP server for distribution to DHCP clients.
If these addresses are not on the same subnet as the access point,
the access point will perform Network Address Translation (NAT)
for the clients to which it grants IP addresses.
Lease Time
Specifies the duration of the leases that are granted by the DHCP
server. Enter the lease time in the format days:hours:minutes.
If you set the lease time to 0, infinite leases are granted.