Allied Telesis AT-WA7500 - Manual (Page 59)

AT-WA7500 User’s Guide
59
8. Select Submit Changes to save your changes. To activate your
changes, select Save/Discard Changes from the menu bar then Save
Changes and Reboot. For help, see Saving Configuration Changes
on page 41.
Supported DHCP Server Options
When the access point is acting as a DHCP server, it issues IP address
leases to configure the IP address, along with the DNS addresses, DNS
suffixes, IP subnet mask, and IP router. These parameters will contain the
same values as those configured for the access point.
Unsupported DHCP Server Options
When the access point is acting as a DHCP server, it does not support any
DHCP options other than those listed. The DHCP server disregards any
DHCP options that are not explicitly required by the DHCP specification.
The DHCP server ignores all frames with a non-zero giaddr (gateway IP
address). The DHCP server only responds to requests from its own
subnet.
About Network Address Translation (NAT)
NAT allows IP addresses to be used by more than one end device. The
access point can act as a NAT server, which instantaneously rewrites IP
addresses and port numbers in IP headers so that frames all appear to be
coming from (or going to) the single IP address of the access point
instead of the actual source or destination.
When an end device uses the access point as an IP router, the access
point replaces the IP header, which includes the device MAC address, IP
source address, and TCP/UDP port, with its own. You can configure the
DHCP server to indicate that the access point is the IP router when the
server allocates an IP address. Special consideration is given to changing
the FTP data connection TCP port number, which is in the body of the
TCP frame. After the frame source is modified, it is forwarded to the
proper subnet.
If the destination subnet is a different subnet from the one the access
point is on, the destination MAC address is changed to the IP router that
has been configured for the access point. If the destination subnet is the
same subnet as the one the access point is on, the access point converts
the MAC address to the MAC address that belongs to the destination IP
address. This may involve using ARP for MAC address discovery.