Allied Telesis AT-WA7500 - Manual (Page 233)

AT-WA7500 User’s Guide
233
FI
Purpose: Reinitializes the access point file system. If
the access point file system or a file
segment becomes corrupt, use this
command to reset it.
Syntax: FI (s)
where s is the optional number of the segment to be reinitialized.
FX
Purpose: Downloads a file using Ymodem batch
protocol into the flash segment that is
specified by s.
Syntax: FX s
where s is segment 1, 2, 3, or 4.
HDW
Purpose: Loads the FPGA configuration file into the
access point. If you are directed to change
the FPGA firmware in the access point, use
this command.
Syntax: HDW f (s)
where:
f is the FPGA configuration filename.
s is the optional segment where you want to load the
configuration file.