Allied Telesis AT-WA7500 - Manual (Page 242)

9 - Additional Access Point Features
242
Using sdvars
Commands
Use sdvars commands to manipulate certain software download
variables. Sdvars commands support both GET and SET arguments. You
can enter sdvars commands to GET a software download object, and
then issue the sdvars command using the SET argument to assign the
object a specified value.
This section describes the sdvars commands using the SET argument. To
execute an sdvars command using the GET argument, omit the variable
from the end of the command.
sdvars set serveripaddress
Purpose: Sets the internal variable called
serveripaddress to a specified address.
Syntax: sdvars set serveripaddress
ipaddress
where ipaddress is the address of the TFTP server.
Example:
To set the IP address of the server to 192.168.49.29, enter:
sdvars set serveripaddress 192.168.49.29
Can’t write remote file The server returns this message if the access
point file system returns an error while the
server is attempting to write the file. This
message is unlikely to occur.
TFTP opcode not read
or write request This error should not occur under normal
operating conditions. This error indicates
that the TFTP client does not conform to the
protocol.
Invalid opcode during
read This error should not occur under normal
operating conditions. This error indicates
that the TFTP client does not conform to the
protocol.
Invalid opcode during
write This error should not occur under normal
operating conditions. This error indicates
that the TFTP client does not conform to the
protocol.
Error Message Explanation