Allied Telesis AT-WA7500 - Manual (Page 104)

4 - Configuring the Radios
104
To configure 802.11a radio inbound filters
1. From the Main Menu, select IEEE 802.11a Radio then Inbound
Filters. The Inbound Filters screen appears.
2. For each frame type, check or clear each check box. The Frame types
are described below:
Allow IAPP
Determines if this radio accepts IAPP frames from other access
point station radios. The IAPP frames must match Ethernet
protocol 875c.
Allow Wireless Transport Protocol (WTP)
Determines if this radio accepts WTP frames from end devices.
The WTP frames must match Ethernet protocol 875b.
Allow UDP Plus (UDP/IP Port 5555)
Determines if this radio accepts UDP Plus frames from end
devices. The UDP Plus frames must match the UDP network port
5555 on the DCS 30X or ARP.