Allied Telesis AT-WA7500 - Manual (Page 20)

1 - Getting Started
20
To install a simple wireless network
1. Configure the initial IP address. For help, see Configuring the Access
Point (Setting the IP Address) on page 35.
2. Install the access point. For help, see Chapter 2, Installing the Access
Points on page 45.
3. Configure the Ethernet network. For help, see Chapter 3, Configuring
the Ethernet Network on page 53.
4. Configure the radios. For help, see Chapter 4, Configuring the
Radios on page 85.
5. Decide what level of security you want to implement in your network.
For help, see Chapter 6, Configuring Security on page 145.
Example - Configuring an 802.11b Access Point
In this example, there is one 802.11b radio in the access point. Wireless end
devices use the access point to communicate with the host and other end
devices.
Table 3 Configuring an 802.11b Access Point Parameters
Screen Parameter Access Point
IEEE 802.11b Radio Node Type
SSID (Network
Name)
Master
ATILAN
Spanning Tree Settings Root Priority
Ethernet Bridging
Enabled
5
Checked
Host
Ethernet
Access
point