Videotec ULISSE COMPACT THERMAL - Manual (Page 48)

EN - English - I
nstruc
tions manual
46
10.12 Manual correction of a preset focusing
Load the preset whose focus needs to be changed using the Scan command; change the focus using the
appropriate keys Focus Far / Focus Near without changing the Pan/Tilt/Zoom position; then save the preset
using the appropriate Preset command.
j The manual correction of the Preset works only if the Daytime/Nigh-time Autofocus fields are
disabled (Fig. 71, page 35).
SPECIAL CONTROLS
Control Protocol
MACRO
PELCO D SENSORMATIC ERNITEC PANASONIC
Tour 1 Record Start Save
Preset 77
Save
Preset 77 Save
Preset 77 Save
Preset 77 Save
Preset 77
Save
Pattern 2 Start recording
pattern 3 Save
Preset 47
Tour 2 Record Start Save
Preset 78
Save
Preset 78 Save
Preset 78 Save
Preset 78 Save
Preset 78
Save
Pattern 3 Save
Preset 48
Tour 3 Record Start Save
Preset 79
Save
Preset 79 Save
Preset 79 Save
Preset 79 Save
Preset 79
Save
Pattern 4 Save
Preset 50
Tour 1 Start Save
Preset 80 Save
Preset 80 Save
Preset 80 Save
Preset 80 Save
Preset 80
Pattern 2 Run pattern 3 Save
Preset 51
Tour 2 Start Save
Preset 81 Save
Preset 81 Save
Preset 81 Save
Preset 81 Save
Preset 81
Pattern 3 Save
Preset 52
Tour 3 Start Save
Preset 82 Save
Preset 82 Save
Preset 82 Save
Preset 82 Save
Preset 82
Pattern 4 Save
Preset 53
Tour Record Stop Iris Open/Close IrisOpen/Close Iris Open/Close Iris Open/Close Iris Open/Close
Ack Save new pattern
Wiper Start Save
Preset 85 Save
Preset 85 Save
Preset 85 Save
Preset 85 Save
Preset 85
Aux 3 ON Aux 3 ON Aux 3 ON Aux 3 ON Save
Preset 54
Wip+
Wiper Stop Save
Preset 86 Save
Preset 86 Save
Preset 86 Save
Preset 86 Save
Preset 86
Aux 3 OFF Aux 3 OFF Aux 3 OFF Aux 3 OFF Save
Preset 55
Wip-
Washer Save
Preset 87 Save
Preset 87 Save
Preset 87 Save
Preset 87 Save
Preset 87
Aux 4 ON Aux 4 ON Aux 4 ON Aux 4 ON Save
Preset 56
Was+