beautypg.com

4 identification, 1 product description and type designation – Videotec ULISSE COMPACT THERMAL User Manual

Page 11

background image

EN - English - I

nstruc

tions manual

9

4 Identification

4.1 Product description and type
designation

ULISSE COMPACT THERMAL offers an integrated
solution for vision even in total darkness, fog, rain,
heavy smoke.
This integrated P&T unit combines an advanced
thermal imaging camera and an optical day/night
zoom module, factory-aligned and installed within
the same enclosure.
ULISSE COMPACT THERMAL features two
independent video outputs and allows dual real-time
vision on monitors for an optimal monitoring of the
area.
ULISSE COMPACT THERMAL offers continuous,
high-speed rotation, positioning precision, superior
image quality, utmost sturdiness and simplified
system configuration. The speed reaches 200°/s in
continuous horizontal rotation, with vertical range
between -90° to +90°.
ULISSE COMPACT THERMAL manages the preset,
auto-pan and patrol functions with an accuracy
0.1°. The unit perform a constant monitoring and
correction of his position, very useful in case of
difficult environmental conditions.
The thermal camera is an Uncooled Vanadium Oxide
microbolometer (VOx) with spectral band 7.5-13.5
µm; it delivers a thermal video of 320x 256 (PAL) and
320x240 (NTSC), with an image frequency of 8.3fps
or 25 fps (PAL) and 7.5 or 30fps (NTSC). The high
sensitivity NEdT 50mK at f/1.0 ensures an optimal
thermal imaging. It supports 2x or 4x digital zoom. A
choice of lens sizes is offered between 35mm, 25mm
and 9mm, depending on the detection distance
required.
The thermal camera parameters are easily
configurable on OSD. The setup interface offers
typical pre-set configurations or complete
customization of the system.
The camera also has functions such as the Isothermal
analysis (special colors of the objects that fall
within the parameters set by the operator), base
thermography and other colors of the scene.
The integrated day/night SONY camera offers a
selection from different zoom lenses, 36x, 18x or
10x, which allows the recording with exceptional
precision of both close-by and far away objects, as
well as dynamic privacy zone masking. Furthermore,
the Super HAD, 1/3” CCD (for 10x optical zoom)
guarantees an excellent sensitivity in poorly lit
environments.

• The main switch must be easily accessible for rapid

intervention when needed.

• Use a Class 2 listed UL tranformer, compliant with

the Standards in force, only for products marked
UL, powered at 24Vac.

• Installation category (also called Overvoltage

Category) specifies the level of mains voltage
surges that the equipment will be subjected to.
The category depends upon the location of the
equipment, and on any external surge protection
provided. Equipment in an industrial environment,
directly connected to major feeders/short branch
circuits, is subjected to Installation Category III. If
this is the case, a reduction to Installation Category
II is required. This can be achieved by use of an
isolating transformer with an earthed screen
between primary and secondary, or by fitting
listed Surge Protective Devices (SPDs) from live
to neutral and from neutral to earth. Listed SPDs
shall be designed for repeated limiting of transient
voltage surges, suitable rated for operating voltage
and designated as follows: Type 2 (Permanently
connected SPDs intended for installation on the
load side of the service equipment overcurrent
device); Nominal Discharge Current (In) 20kA min.
For example: FERRAZ SHAWMUT, STT2240SPG-CN,
STT2BL240SPG-CN rated 120/240Vac, (In=20kA).
Maximum distance between installation and
reduction is 5m.

• This is a Class A product. In a domestic

environment this product may cause radio
interference in which case the user may be
required to take adequate measures.