Videotec ULISSE COMPACT THERMAL - Manual (Page 15)

EN - English - I
nstruc
tions manual
13
7.1.2 Fixing the base to the support
h Use the screws and the washers supplied
with the base.
After having positioned gasket (01), fasten base (02)
on support (03) using screws (04), toothed spring
washers (05) and the flat washers (06). Insert the
screw-sealing OR (07).
01
06
07
05
02
03
04
Fig. 07
03
01
07
02
06
05
04
Fig. 08
Align the 3 notches on the base with those on the
support as shown in the following figure.
Fig. 09
h Apply a Loctite 243® type thread-locker on
the holes of the screws.
h Fasten with tightening
torque of 4Nm.
7 Assembling and
installing
h Only specialised personnel should be
allowed to assemble and install the device.
h This is a Class A product. In a domestic
environment this product may cause radio
interference in which case the user may be
required to take adequate measures.
7.1 Installation
7.1.1 Connecting the cables to the base
h Do not make any changes or install
connections that are not included in this
handbook. Failure to follow the connection
instructions that are given in the handbook
may create serious safety hazards for
people and for the installation.
h Do not change the wiring in the product
as it is supplied to you. Failure to follow
this instruction may create serious safety
hazards for people and for the installation,
and will also invalidate the guarantee.
j Keep a connection diagram for future
reference.
Insert the cables into the cable glands and, holding
the base at about 20cm from the support, lock
the cable glands with a torque wrench setting of
5Nm. The cable glands are suitable for cables with
diameters of between 5 and 10mm.
Fig. 06