HP Insight Control - Manual (Page 60)

•
30 seconds
•
60 seconds
If you cannot establish the source-to-destination or application-station-to-destination connection, the Next
button is disabled. Ensure that ports 51125 and 51126 are open between source and destination
servers.
If you establish the source-to-destination or application-station-to-destination connection but the network
test reports a transfer speed below 250 kb/s, the Next button is disabled.
If you establish the source-to-destination or application-station-to-destination connection and the network
test reports a transfer speed of at least 250 kb/s, the Next button is enabled.
CAUTION: If the application-station-to-destination latency is less than 125 milliseconds, continue with
the migration. Latency greater than 125 milliseconds might cause driver injection issues.
11. Click Next.
12. Use the following steps to assign source disks to destination disks:
1. Map source disks to destination disks.
2. Ensure that migrated disks fit on their mapped destination disks.
For migrating the boot partition, HP Insight Control server migration needs extra space for creating
/-smpue for each of the valide initrd entries in partition>/grub/menu.lst. Each valid entry has a corresponding file name uncer the
60 Using Insight Control server migration to migrate servers