HP XP P9000 Performance Advisor Software User Manual
Page 204
Table 15 Continuous access configuration data
Description
Screen element
Serial number of the primary XP or P9000 disk array
(primary data center).
Primary Array
LDEV configured as P-VOL on the primary data center.
Displays the LDEV number in cu:ldev format.
PVOL
Serial number of the secondary XP or P9000 disk array.
Secondary Array
LDEV configured as S-VOL on the secondary data center.
Displays the LDEV number in cu:ldev format.
SVOL
Current replication link status of the P-VOL or S-VOL on the
selected XP or P9000 disk array. The replication link status
Pair Status
shown is corresponding to the continuous access
transactions happening on the selected XP or P9000 disk
array, and can be one of the following:
•
SMPL
•
COPY
•
PAIRED
•
Pair Suspend
•
Pair Suspend Error
•
Pair DUB
•
Reverse Copy
•
Pair SideFile 30% over
•
Pair SideFile over Suspend
•
SVOL Swap ready Suspend
•
Unknown
Type of volume (PVOL or SVOL) configured on the primary
data center.
Volume Type
Thick or Thin, indicates virtual volume or physical LDEV.
Provision Type
Failed or Active.
NOTE:
When Continuous access is configured as Sync
or Async and the selected volume type is SVOL, then you
might encounter the CA Link status as NA - Not Applicable.
CA Link Status
Alarm configuration for the CA pair status. HP XP P9000
Performance Advisor retrieves the CA pair status during
Pair Status Alarm
each performance cycle. If there is a change in the pair
status from the previous performance cycle, an email
notification is sent to the email address specified on the
Email Settings screen. These notifications are not sent if
there is an intermediate change in the pair status during a
performance cycle.
Number of active continuous access paths from a PVOL to
SVOL.
No. of Paths
NOTE:
When Continuous Access is configured as Sync
or Async and the selected volume type is SVOL, then you
might encounter the status of the number of paths as NA -
Not Applicable.
204 Viewing XP and P9000 disk array components