Configuring a remote copy over ip port – HP 3PAR T-Class Storage Systems User Manual

Page 163

3PAR InForm Management Console 4.1.0 User’s Guide

320-200231 Rev A

163

Configuring a Remote Copy over IP Port

To configure a Remote Copy over IP (RCIP) port, access the RCIP Port Configuration
wizard:

1. In the Manager Pane, click Systems.
2. In the Management Tree, select the system on which you wish to configure the port.
3. In the Common Actions Panel, click Configure RCIP Port.

The RCIP Port Configuration wizard appears.

4. In the General group box:

a. System list - Select the system on which the port will be configured.
b. Port list - Select the port to be configured as an RCIP port.

5. In the IP Settings group box:

a. IP Address - Enter the IP address of the RCIP port. The IP address is required.

b. Subnet Mask - Enter the RCIP port's subnet mask. The subnet mask is required.
c. Gateway - Enter the RCIP port's gateway address.

d. MTU list -Enter the MTU value.
e. Speed list - Select the port speed as Auto (default), 10 Mbps, 100 Mbps, or 1

Gbps.

f. Duplex list - Select the port's duplex value of either Half or Full.

6. Click OK.