HP 3PAR T-Class Storage Systems - Manual (Page 122)

3PAR InForm Management Console 4.1.0 User’s Guide
122 320-200231 Rev A
are connected to drive cages and ports in Target
mode export to hosts. Suspended mode is for target
ports that have not yet been initialized by the system
(rare). Peer mode is for Ethernet ports.
State Current state of the port.
MAC
(not shown) For iSCSI ports. The Media Access Control address for
the Ethernet interface.
TPGT
(not shown)
For iSCSI ports. The Target Portal Group Tag for the
iSCSI target portal group.
Resources
Total Data
Throughput
The throughput in KIB/sec.
Settings
(displayed for FC
and RCFC ports)
Connection
Mode
The type of port connection.
Connection
Type
Connection type or port connection setting (Loop,
Point, or Loop-point). When the port is set to Loop-
point, both loop and point-to-point connections are
enabled.
Configured
Rate
Data transfer rate setting (for example,
1 Gbps). Auto indicates that the system
automatically selects the rate.
Max Rate Maximum rate of connection from the port.
Class 2
Indicates whether Fibre Channel service Class 2 is
Disabled, Ack 1 or Ack 0.
VCN
For fabric attached ports, indicates the VLUN change
notification setting. When set to Enabled, notices are
generated and sent to the fabric controller. When set
to Disabled, no notification is sent.
Unique Node
WWN Indicates whether the node's WWN is Enabled or
Disabled.
Interrupt
Coalesce
If Disabled, each I/O generates a separate interrupt
to the HBA port driver rather than generating one
interrupt for multiple I/O completion.
IP Settings
(displayed for
RCIP and iSCI MAC
For RCIP ports. Media Access Control address of the
Ethernet interface.