HP 3PAR T-Class Storage Systems - Manual (Page 135)

3PAR InForm Management Console 4.1.0 User’s Guide
320-200231 Rev A 135
Unique Node
WWN
Indicates whether the node's WWN is Enabled or
Disabled. Not available for systems running InForm OS
2.2.4 or lower.
Interrupt
Coalesce
If Disabled, each I/O generates a separate interrupt to
the HBA port driver rather than generating one interrupt
for multiple I/O completion. Not available for systems
running InForm OS 2.2.4 or lower.
Fibre
Channel
Settings
Topology
Type of connection (Private Loop, Public Loop, or
Point-Point).
Class
Identifies which Fibre Channel classes of service are
enabled (2, 3, or 2/3). 2/3 indicates that both Class 2
and Class 3 are enabled.
Adaptor Type
Model of the Fibre Channel adapter that contains the
port (for example, QLOGIC 2302).
Mode Change
Indicates whether port mode change from initiator to
target or vice versa is Allowed or Prohibited. This
setting is configured using the InForm CLI command
controlport.
Hosts
The number of hosts connected to the port. This is only
displayed if the port is connected to hosts.
Physical
Disks
The number of physical disks connected to the port. This
is only displayed if the port is connected to drive cages.
Note: Persona information is not displayed on systems using InForm OS 2.3.1 or higher.
Persona
(not shown)
Persona Number for the current port persona setting.
Vendor
Manufacturer of the host computer’s network adapter.
This value is determined by the port persona.
Adapter Type
Host computer's network adapter. This value is
determined by the port persona.
OS
Host computer’s operating system. This value is
determined by the port persona.