HP 3PAR T-Class Storage Systems - Manual (Page 123)

3PAR InForm Management Console 4.1.0 User’s Guide
320-200231 Rev A 123
ports - not
shown) DHCP
For iSCSI ports. Indicates if the Dynamic Host
Configuration Protocol (DHCP) protocol is enabled.
IP Address IP address of the iSCSI or RCIP port.
Gateway
The address of a local IP router on the same network
as the InServ, used to forward traffic to destinations
beyond the local network.
Subnet Mask Netmask address for the iSCSI or RCIP interface.
MTU
Maximum Transmission Unit. The greatest amount of
data or "packet" size that can be transferred in one
physical frame on a network. MTU setting for the
iSCSI port. The default setting is 1500. When
supported by the network, an MTU value of 9000
should be used.
Configured
Rate
For RCIP ports. The configured data transfer rate. A
value of 0 indicates that no data is being transferred.
Rate
For iSCSI ports. Data transfer rate. A value of 0
indicates that no data is being transferred.
TCP Port The TCP port number used by the iSCSI card.
Duplex (For RCIP) The duplex speed, Half or Full.
Adapter Type
For RCIP ports. Model of the adapter that contains the
port (for example, Intel PRO/1000MT).
Fibre Channel
Settings
(displayed for FC
and RCFC ports)
Topology
Type of connection (Private Loop, Public Loop, or
Point-Point).
Class
Identifies which Fibre Channel classes of service are
enabled (2, 3, or 2/3). 2/3 indicates that both Class
2 and Class 3 are enabled.
Adaptor Type
Model of the Fibre Channel adapter that contains the
port (for example, QLOGIC 2302).