ADIC SNC 5100 - Manual (Page 81)

Ethernet MAP 73
6-00020-02
SNC 5100
Step 20. From the service terminal, enter the reboot command and wait for
the SNC 5100 to finish booting.
Go back to step 14.
Step 21. Enter the command ping “ ” , where
IP address> is four decimal numbers separated by periods.
is the address provided by the network
administrator for PING testing.
Display of successful PING test:
Example:
SN60023 > ping “192.168.1.1”, 10
PING 192.168.1.1: 56 data bytes
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
64 bytes from 192.168.1.1: icmp_seq=0. time=0. ms
----192.168.1.1 PING Statistics----
10 packets transmitted, 10 packets received, 0% packet loss
round-trip (ms) min/avg/max = 0/0/0
value = 0 = 0x0
Display of failed PING test:
Example:
SN60023 > ping “192.168.1.251”,10
PING 192.168.1.251: 56 data bytes
request timed out
value = -1 = 0xfffffff
Step 22. If the PING test passes, go to step 23.
If the PING test fails, inform the system administrator that there is a
network hardware problem where the SNC 5100 is attached.
Exit this MAP.