ADIC SNC 5100 - Manual (Page 147)

Commands 139
6-00020-02
SNC 5100
network. Interpreting these statistics requires detailed knowledge of Internet
networking protocols. This information may be useful to the LAN
administrator.
SN60023 > icmpstatShow
ICMP:
0 call to icmp_error
0 error not generated because old message was icmp
0 message with bad code fields
0 message < minimum length
0 bad checksum
0 message with bad length
Input histogram:
destination unreachable: 1
0 message response generated
value = 30 = 0x1e
SN60023 >
ifShow
The ifShow command is used to show the Ethernet port parameters and status
as shown below. The SNC 5100 will show two devices. ibmEmac is the
Ethernet port. lo is the local loopback port.
SN600752 > ifShow
ibmEmac (unit number 0):
Flags: (0x8063) UP BROADCAST MULTICAST ARP RUNNING
Type: ETHERNET_CSMACD
Internet address: 172.16.76.211
Broadcast address: 172.16.255.255
Netmask 0xffff0000 Subnetmask 0xffff0000
Ethernet address is 00:60:45:17:02:f0
Metric is 0
Maximum Transfer Unit size is 1500
114192 packets received; 364 packets sent
114023 multicast packets received
116 multicast packets sent
0 input errors; 0 output errors
0 collisions; 0 dropped
lo (unit number 0):
Flags: (0x8069) UP LOOPBACK MULTICAST ARP RUNNING
Type: SOFTWARE_LOOPBACK
Internet address: 127.0.0.1
Netmask 0xff000000 Subnetmask 0xff000000