ADIC SNC 5100 - Manual (Page 50)

SNC 5100
42 Start MAP
6-00020-02
Event Viewing Levels
Numerical equivalents for the Event viewing levels from the Viewing Level
column of Table 8 are explained in Table 9.
Start MAP
Gather as much information as possible before performing a repair action.
When gathering information, you may need to connect the service terminal to
the service port. See “Connecting to the Service Port” on page 95.
For the latest information on the SNC 5100, visit www.adic.com .
Event Code or Obvious Symptom
Either an Event Code has been reported by the ADIC Management Console or
an error has been observed by other means.
7 Go to “Ethernet MAP” on page 69
8 Go to “Service Port MAP” on page 75
9 Contact your network administrator
10 Reduce the number of target devices attached to the SNC 5100
11 Go to “Start MAP” on page 42
12 Go to “Device Access MAP” on page 48
13 Go to “Retrieving the Code 43 Dump File” on page 189
Table 9: Event Viewing Levels
Number Level Explanation
0 Notice Events recorded in the Event Log but not displayed by the
Event Viewer
1 Warning Includes events that should always be reported, such as
device removals, and changes to temperature or power
systems
2 Information Includes events that might result in later problems
Table 8: Action Reference Table
Action
Number Action