ADIC SNC 5100 - Manual (Page 179)

Commands 171
6-00020-02
SNC 5100
firmware, Power-On-Self-Test (POST), bootrom and Alternate bootrom.
SN600726 > showVersions
ADIC Scalar Storage Network Controller Firmware-4
Version 0404.05 Built Oct 19 2001, 14:40:29 on 5xame by jsmyder
POST version v040405
Bootrom version v040405
Alt Bootrom version v040405
value = 0 = 0x0
SN600726 >
sncFeatureEnable "licensekeystring"
The sncFeatureEnable command enables the optional Data Mover feature.
You enable the feature by entering the unique license key.
SN60023 > sncFeatureEnable “BVRXC-G79DN”
value = 0 = 0x0
SN60023 >
Caution
If the license key was factory-installed, you can enter the word
“enable” rather than the actual license key.
SN60023 > sncFeatureEnable “enable”
value = 0 = 0x0
Data Mover License is Valid
SN60023 >
If value = 1 = 0x1 message is displayed, it means the license is already
installed and Data Mover is already enabled.
If the value = -1 = 0xffffffff message is displayed, it means the
license is not already installed and you do need to enter the license key.
snmpCommunitiesShow
The snmpCommunitiesShow command displays the list of SNMP community
strings in use by the SNC 5100.
SN60023 > snmpCommunitiesShow
ReadCommunity ViewIndex
-----------------------------