ADIC SNC 5100 - Manual (Page 116)

SNC 5100
108 Commands
6-00020-02
loggerDump Display Event Log records 141
loggerDumpCurrent Display Event Log records for current boot 142
supportDump Display information used in troubleshooting 195
Fibre Channel
fcConnTypeGet Display the current setting of a Fibre
Channel port’s connection type 121
fcConnTypeSet Set the type of connection for a Fibre
Channel port 122
fcFibreSpeedGet Display maximum and current speeds of
Fibre Channel port 123
fcFibreSpeedSet Set Fibre Channel port speed 123
fcGbicShow Display the GBIC information for each
installed GBIC 123
fcPortModeGet Display the mode for the specified Fibre
Channel port 125
fcPortModeSet Set the mode for the specified Fibre
Channel port 126
fcRestart Restart the specified Fibre Channel port 126
fcShow Display Fibre Channel interface status 127
fcShowDevs Display attached SCSI and Fibre Channel
Target Devices from Fibre Channel port
perspective 129
fcShowNames Display Node and Port names for Fibre
Channels 130
fcTxDisable Disable a Fibre Channel port transmitter 130
fcTxEnable Enable or re-enable a Fibre Channel port
transmitter 130
setFcFrameSize Set Frame Size for specific Fibre Channel
port 161
setFcHardId Set Loop ID for specific Fibre Channel port 162
Table 13: Commands Listed Alphabetically byFunction
Command or Command
Group
Description Page