ADIC SNC 5100 - Manual (Page 114)

SNC 5100
106 Commands
6-00020-02
setSnaCCLun Change Command and Control Interface
LUN 164
Data Mover
sncFeatureEnable Enable the optional Data Mover feature 171
Diagnostics
Diagnostic commands are located in
“Diagnostic Command Reference” on
page 187.
Environmental Sensors
envMonShow Display all environmental channel states 118
Ethernet Network
arptabShow Display a list of known ARP entries 114
ethAddrGet Display Ethernet Port address 120
ethAddrSet Set Ethernet Port address 121
gateAddrGet Display network gateway address 131
gateAddrSet Set network gateway address 131
host “ add ” Add host table entries 135
host “delete” Delete network host table entries 136
host “list” List network host table entries 137
hostNameSet Change SNC 5100’s network name 138
icmpstatShow Display statistics for ICMP 138
ifShow Display Ethernet Port parameters and status 139
inetstatShow Display all Internet protocol sockets 140
ipstatShow Display statistics for IP 141
macShow Display Ethernet Port Media Access
Control address 143
mbufShow Display mbuf statistics 148
route Edit route table entries 153
Table 13: Commands Listed Alphabetically byFunction
Command or Command
Group
Description Page