ADIC SNC 5100 - Manual (Page 133)

Commands 125
6-00020-02
SNC 5100
fcPortModeGet [port]
The fcPortModeGet command displays the mode for the specified Fibre
Channel port. The default port mode is Public Target. See also the
fcPortModeSet command.
After the command executes, the number displayed as a value indicates the port
mode as follows:
The following example shows how the connection type is displayed when Fibre
Channel port 1 is specified and the port mode is Private Target.
SN6002 >fcPortModeGet 1
value = 1 = 0x1
SN6002 >
Caution
You must issue the fcRestart command or reboot the SNC 5100
for the new setting to take effect. See the fcRestart command for
further information.
Parameter Value Meaning
Port 1 The SNC 5100 connection labeled FC1
2 The SNC 5100 connection labeled FC2
Value Port Mode
1 Private Target
2 Private Initiator
3 Private Target and Initiator
17 Public Target
18 Public Initiator
19 Public Target and Initiator