ADIC SNC 5100 - Manual (Page 190)

SNC 5100
182 Commands
6-00020-02
0 discarded for bad header offset field
0 discarded because packet too short
0 connection request
1 connection accept
1 connection established (including accepts)
1 connection closed (including 0 drop)
0 embryonic connection dropped
272 segments updated rtt (of 272 attempts)
0 retransmit timeout
0 connection dropped by rexmit timeout
0 persist timeout
1 keepalive timeout
1 keepalive probe sent
0 connection dropped by keepalive
value = 36 = 0x24 = '$
SN60023 >
trapDestAdd “ ipAddress ”
The trapDestAdd command allows you to add an ethernet address as a trap
recipient to the SNMP trap destination table that is maintained within the SNC
5100. The broadcast address for the Ethernet port is also automatically
included in the table. When the ADIC Management Console is running, it
inserts its address into the table automatically.
For more information, see the ADIC Management Console User Guide.
SN60023 > trapDestAdd 192.168.1.75
value = 0 = 0x0
SN60023 >
trapDestRemove “ ipAddress ”
The trapDestRemove command allows you to remove an ethernet address as
a trap recipient from the SNMP trap destination table that is maintained within
the SNC 5100. When the ADIC Management Console is running, it inserts its
address into the table automatically.
For more information, see the ADIC Management Console User Guide.
The broadcast address for the Ethernet port is also automatically included in
the table
SN60023 > trapDestRemove “10.0.0.2”
value = 0 = 0x0
SN60023 >