ADIC SNC 5100 - Manual (Page 182)

SNC 5100
174 Commands
6-00020-02
For more information, see the ADIC Management Console User Guide.
SN60023 > snmpWriteCommunityAdd “adic”,1
Success
value = 0 = 0x0
SN60023 >
snmpWriteCommunityRemove “ string ”
The snmpWriteCommunityRemove command removes the specified string
from the list of accepted strings for SNMP Write operations.
SN60023 > snmpWriteCommunityRemove “adic”
Success
value = 0 = 0x0
SN60023 >
sysConfigShow
The sysConfigShow command displays current system parameter settings.
The display shows whether or not the SNC 5100’s Command and Control
interface is enabled or disabled and the LUN that is assigned to it, whether or
not enhanced tape performance features are enabled, the MAC address of the
Ethernet port; and the SNC 5100’s Fibre Channel Node address.
SN60023 > sysConfigShow
Current System Parameter Settings:
Command and Control Device (CC) : 0 Enabled
LUN : 0
Allow Early Write Status for Tape : 1 Enabled
Allow R/W Acceleration for Tape : 1 Enabled
Enet MAC Address: 0.60.45.16.1.4
FC Node WWN: 10000060.45160104
value = 0 = 0x0
SN60023 >
sysNodeNameModeSet [Mode]
The sysNodeNameModeSet command changes the Fibre Channel Node Name
Mode for the Fibre Channel interface ports. In the default mode (Mode 0), each
Fibre Channel port on the SNC 5100 has the same node name. For
configurations that require the node name to be different, use the
sysNodeNameModeSet command to change the mode to 1.