Firmware version, Hardware version, Firmware version hardware version – ADIC SNC 5100 User Manual
Page 53
Start MAP
45
6-00020-02
SNC 5100
Step 1.
Start the ADIC Management Console Server and Client.
For installation and operating instructions, as well as access to
version information, see the ADIC Management Console User
Guide.
Step 2.
If an update is needed, download the update from www.adic.com,
and perform the update.
Firmware version
Use this procedure to check the firmware version level.
Step 1.
Connect a service terminal to the SNC 5100.
For information about how to do this, see “Connecting to the
Service Port” on page 95.
Step 2.
Press the Enter key on the service terminal.
If the prompt is not displayed, go to “Service Port MAP” on
page 75.
Step 3.
Issue the
showVersions
command.
Step 4.
If an update is required, download the update from www.adic.com,
and perform the update.
Hardware version
Use this procedure to check the hardware version information.
Step 1.
Connect a service terminal to the SNC 5100.
For information about how to do this, see “Connecting to the
Service Port” on page 95.
Step 2.
Press the Enter key on the service terminal.
If the prompt is not displayed, go to “Service Port MAP” on
page 75.