ADIC SNC 5100 - Manual (Page 165)

Commands 157
6-00020-02
SNC 5100
SN60023 >
Caution
You must reboot the SNC 5100 after executing this command for
the new setting to take effect.
scsiHostChanGet [channel]
The scsiHostChanGet command displays Host Channel modes for a SCSI
channel. If no channel is specified, Host Channel modes are displayed for all
SCSI channels.
SN60023 > scsiHostChanGet
SCSIbus HostChan ------- ---------------
SCSI 1 Channel is Target
SCSI 2 Channel is Initiator
value = -1 = 0xffffffff
SN60023 >
scsiHostChanSet [channel],[mode]
The scsiHostChanSet command sets the Channel Mode to Target or
Initiator for the specified SCSI Channel.
SN60023 > scsiHostChanSet 2,1
Host Chan set to TARGET for SCSI 2 will take effect upon reboot
value = 0 = 0x0
SN60023 >
Caution
You must reboot the SNC 5100 after executing this command for
the new settings to take effect.
Parameter Value Meaning
SCSI Channel Number 1 - 4 Selected Channel
Mode 0 Initiator
1 Target