ADIC SNC 5100 - Manual (Page 166)

SNC 5100
158 Commands
6-00020-02
scsiHostIdGet [channel]
The scsiHostIDGet command displays the Host ID number for a specified
SCSI Channel. If no channel is specified, Host IDs are displayed for all SCSI
channels.
SN60023 > scsiHostIdGet
SCSIbus HostId ------- ---------------
SCSI 1 7
SCSI 2 7
value = -1 = 0xffffffff
SN60023 >
scsiHostIdSet [channel],[id]
The scsiHostIdSet command sets the Host ID for a specified SCSI
Channel.
SN60023 > scsiHostIdSet 2,7
Host Id set to 7 for SCSI 2
will take effect upon reboot
value = 0 = 0x0
SN60023 >
Caution
You must reboot the SNC 5100 after executing this command for
the new settings to take effect.
scsiRescan [channel]
The command scsiRescan requests a SCSI rescan for new devices. If channel
is specified (1 or 2), then only that channel is scanned. Otherwise, if channel is
not specified or if channel is 0, then all channels are scanned.
SN60023 > scsiRescan 2
Done
Parameter Value
Channel Number 1 - 4
ID 0 -15