ADIC SNC 5100 - Manual (Page 168)

SNC 5100
160 Commands
6-00020-02
SN60023 > scsiResetDisableSet 1,1
Reset Disable set to TRUE for SCSI 1
will take effect upon reboot
value = 0 = 0x0
SN60023 >
scsiShow
The scsiShow command displays all SCSI channels and information about
the devices attached to each channel. The following example shows the display
for a tape library attached to SCSI Channel 2:
SN60023 > scsiShow
SCSI Initiator Channel 2: 0xc08d26e0
ID LUN Vendor Product Rev | Sync/Off Width
--------------------------------------|------------
0 0 OEM 03570C12 5346 | 25/15 16 S W 0/ 0 8 S W
0 1 OEM 03570C12 5346 |
1 0 OEM 03570C12 5346 | 25/15 16 S W 0/ 0 8 S W
value = 0 = 0x0
SN60023 >
ID The SCSI ID of the target device
LUN The SCSI LUN of the target device
Vendor The content of the Vendor ID field from the
SCSI Inquiry Data
Product The content of the Product ID field from the
SCSI Inquiry Data
Rev The content of the Revision ID field from the
SCSI Inquiry Data
Sync/Off The negotiated synchronous transfer period and
offset. The period is the negotiated transfer
period. Multiply the period times 4 nanoseconds
Parameter Value Meaning
Channel Number 1 - 4 Selected Channel
Mode 0 Enable Reset on Power Up
1 Disable Reset on Power Up