ADIC SNC 5100 - Manual (Page 178)

SNC 5100
170 Commands
6-00020-02
interface is opened, the Service Port interface is not available. The shellLock
command may be used to prevent a network protocol access to the shell.
A numeric parameter specifies if the shell is to be locked or unlocked. If the
parameter is 0, then the shell is unlocked.
SN60023 > shellLock 1
value = 1 = 0x1
SN60023 >
.. Shell is now locked
SN60023 > shellLock 0
value = 1 = 0x1
showBox
The showbox command displays components of the SNC 5100 using
characters to form a picture of the unit, as viewed from the back of the SNC
5100:
SN60023 > showBox
Back _________________________________________
/ /|
/ / |
/ / |
/ / |
/========================================/ |
| FC1 FC2 | |
| [SW-2] [SW-2] | /
| | /
| [LVDT] [LVDT] [LVDT] [LVDT] | /
| SCSI1 SCSI2 SCSI3 SCSI4 | /
|________________________________________|/ Front
LVDT = SCSI Low Voltage Differential - Terminated
SW-2 = Short Wave - Two GB
value = 0 = 0x0
SN60023 >
The abbreviations used in the drawing are explained in the legend immediately
below the drawing.
showVersions
The showVersions command displays the version of the operational