ADIC SNC 5100 User Manual
Page 131
Commands
123
6-00020-02
SNC 5100
fcFibreSpeedSet [port],[speed]
The
fcFibreSpeedSet
command sets the Fibre Channel port speed to 1
Gb/sec or 2 Gb/sec for a Fibre Channel port. The port can also be set to
autorange, as in the example below
.
SN60023 > fcFibreSpeedSet 1,0
value = 0 = 0x0
SN6002 >
Caution
You must issue the
fcRestart
command or reboot the SNC 5100
for the new setting to take effect. The initiator and the device must
both be capable of the selected speed. See the
fcRestart
command for further information.
fcGbicShow [port]
The
fcGbicShow
command displays the GBIC information for each installed
2
The SNC 5100 Connection labeled FC2
value =
0
Speed is set to Autorange
1
Speed is set to 1 Gb/sec
2
Speed is set to 2 Gb/sec
Parameter
Value
Meaning
Port
1
The SNC 5100 connection labeled FC1
2
The SNC 5100 connection labeled FC2
Speed
0
Autorange
1
1 Gb/sec
2
2 Gb/sec
Parameter
Value
Meaning