ADIC SNC 5100 - Manual (Page 139)

Commands 131
6-00020-02
SNC 5100
SN60023 > fcTxEnable 1
value = 0 = 0x0
SN60023 >
gateAddrGet
The gateAddrGet command displays the default network gateway address if
one has been set. This address is used when connections are made to a different
subnet and there are no explicit routes defined for that subnet. Consult your
network administrator for more information on the default gateway (sometimes
referred to as default router) address.
SN60023 > gateAddrGet
Gateway Address set to 192.168.1.1
value = 0 = 0x0
SN60023 >
gateAddrSet
The gateAddrSet command changes the default network gateway address.
This address is used when connections are made to a different subnet and there
are no explicit routes defined for that subnet. Consult your network
administrator for more information on the default gateway (sometimes referred
to as default router) address.
Successful gateAddrSet
SN60023 > gateAddrSet “10.0.0.1”
value = 0 = 0x0
SN60023 >
Failed gateAddrSet (1)
The following message is received when trying to set a new gateway address
and that address is currently unreachable. The following message is sent to the
Parameter Value Meaning
Port 1 The SNC 5100 connection labeled FC1
2 The SNC 5100 connection labeled FC2