ADIC SNC 5100 - Manual (Page 136)

SNC 5100
128 Commands
6-00020-02
SN600032 > fcShow
------------------Fibre Channel Controllers-----------------------
Ctlr : PCI Addr : ISP : Firmware : Firmware : Loop : Fabric : Port : E
xt. : Link
Id : Bs Dv Fn : Type : State : Version : ID : Attached : Mode : F
IFO : Speed
------------------------------------------------------------------
1 : 00 07 00 : 2300 : Sync Lost : 3.00.25 : None : No : Targ : N
one : 1 Gbps
2 : 00 08 00 : 2300 : Sync Lost : 3.00.25 : None : No : Targ : N
one : 2 Gbps
------------------------------------------------------------------------------
value = 95 = 0x5f = ‘_’
SN600032 >
Ctlr Id Indicates the Port Number for this interface.
PCI Addr The PCI address of the interface, showing bus,
device id, and function number.
ISP Type The type of Fibre Channel Controller.
Firmware State The current state of the interface as reported by
the Fibre Channel controller. Firmware states are
listed below.
Configuration Wait Firmware is not initialized.
Waiting for AL_PA Firmware is performing or waiting to perform
loop initialization.
Waiting for login Firmware is attempting port and process logins
with all loop ports.
Ready Indicates that the interface is connected and
operational and ready to process SCSI
commands. Any other value indicates
intermediate states or interface failure.
Sync Lost The firmware has detected a loss-of-sync
condition and is re-synchronizing the serial link
receiver. This is the state reported when the Fibre
Channel link does not detect a connection to a
Fibre Channel device.
Error The firmware has detected an unrecoverable
error condition.
Nonparticipating The firmware is not participating on the loop
since it did not acquire an AL_PA during
initialization.
Failed The firmware is not responding to commands.
Firmware Version The version of firmware on the Fibre Channel