ADIC SNC 5100 - Manual (Page 162)

SNC 5100
154 Commands
6-00020-02
route “ delete ” , ” destination ” , ” gateway ”
The route “ delete ” command removes a route to the destination through
the gateway.
SN60023 > route "delete","200.0.0","bruno"
SN60023 >
route “ list ”
The route “ list ” command lists the existing routes.
SN60023 > route "list"
Destination SNC 5100
-------------------- --------------------
socrates bruno
Destination SNC 5100
-------------------- --------------------
200.0.0 bruno
value = 0 = 0x0
SN60023 >
rtcDateSet[year],[month],[dayofmonth],[dayofweek],
[hour],[minute],[second]
The rtcDateSet command allows you to set the date and time manually.
• You must use a 24-hour clock.
• All parameters are digits.
• The year can be either two or four digits.
• Single digit months or hours should not be filled out with leading zeroes.
• A digit from 1-7 needs to be entered for the [dayofweek] parameter, but
it doesn’t matter what you enter, since the command will automatically
correct it if it is wrong.
To display the new time and date data after entering the rtcDateSet
command, enter the date command.
To set the RTC to 9:35 A.M. on Friday, January 26, 2001, enter the following