ADIC SNC 5100 - Manual (Page 129)

Commands 121
6-00020-02
SNC 5100
ethAddrSet
The ethAddrSet command changes the IP address of the SNC 5100. An IP
address is specified as 4 decimal numbers separated by periods.
SN60023 > ethAddrSet "192.168.1.54"
Host Address set to 192.168.1.54 for Ethernet interface
value = 0 = 0x0
SN60023 >
If a netmask is required, specify it after the IP address in “dotted decimal”
form.
For example:
SN60023 > ethAddrSet "10.0.0.2","255.255.0.0"
Inet Mask set to ffff0000 for Ethernet interface
Write complete
Host Address set to 10.0.0.2 for Ethernet interface
value = 0 = 0x0
SN60023 >
fcConnTypeGet [port]
The fcConnTypeGet command is used to display the current setting of a
Fibre Channel port’s connection type. See also the fcConnTypeSet
command.
The following example shows how the connection type is displayed when Fibre
Channel port 1 is specified and its connection type is loop.
SN600012 > fcConnTypeGet 1
value = 0 = 0x0
SN600012 >
Parameter Value Meaning
port 1 The SNC 5100 Connection labeled FC1
2 The SNC 5100 Connection labeled FC2
connection type 0 Loop
1 Point-to-point
2 Loop preferred