GW Instek APS-1102 Control Software User Manual - Manual (Page 98)

APS-1102 Control Software User Manual
9-8
Clicking the [Step stop phase [deg]] cell displays the radio buttons with which the stop phase
can be enabled or disabled, as shown in “Figure 9-5”. The stop phase can be enabled or disabled by
switching the radio button setting. If Disable is selected, the corresponding cell will gray out and it
will not accept any entry. If Enable is selected, the cell will display the default value.
Clicking here displays the radio buttons with
which the step stop phase can be enabled or
disabled.
Figure 9-5 Step Stop Phase Setting