GW Instek APS-1102 Control Software User Manual - Manual (Page 69)

8.1 Generation of Standard Waveform and Numerical Expression
Waveform
8-5
8.1.4 Inter-Waveform Numerical Expression
Selecting [Waveform Function] in “8.1.2 Waveform selection” displays the constant input
section [Constant] and numerical expression input section [Y=].
Figure 8-2 Waveform Generation Screen - Waveform Function
Input the constant and expression and click the Compute button to check the calculated waveform
in the waveform display on the waveform generation screen.
To create the waveform on all pages in the batch, click the
All Page OK button at the bottom of the
screen.
To create the waveform on the displayed page only, click the
Page OK button at the bottom of the
screen.
To return to the waveform display screen without creating a waveform, click the
Cancel button at
the bottom of the screen or press the Esc key.
a) Constants
Describe the constant in the [constant=value or expression] format uch as [fs=32767;] and
[s=2*pi/4096;]. Be sure to suffix a constant definition or expression with [;].
Use 1-byte characters for the constant or expression. Constants and expressions are not case
sensitive.
The constant should begin with an alphabetic character and consist of alphanumeric characters.